Monday, August 27, 2018

Code Alarm AS9233ST Remote Programming Instructions

This Code Alarm AS9233ST system uses replacement remote: ELVATCC, CATX420

Programming your new transmitter:

1) Enter the vehicle, and turn the ignition switch to the ON position.
2) Press and release the programming button 3 times.
3) Press and hold the button of the transmitter you wish to program for 3 seconds, or until the parking lights flashes 1 time. indicating the transmitter has been programmed to the system.
4) Repeat step 3 for each transmiterup to a total of 4.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below