Monday, August 27, 2018

Code Alarm CA120 Remote Programming Instructions

This Code Alarm CA120 system uses replacement remote: CATX120, GOH-PAN05

The keychain transmitters included with the system have been pre-programmed at the factory, with each button pre-assigned to control a specific function of the system. It is important to remember that during programming, each individual step of the procedure must be executed within 15seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically terminate the programming mode. This is indicated by a long chirp from the siren.

Additionally, the system will store codes from up to 4different transmitters. If a 5th transmitter is programmed to any receiver channel, then the first transmitter programmed to that channel will be erased from the system’s memory.

To program new or additional transmitters, the alarm must be disarmed and the valet switch must be in the OFF position:

1. Enter the vehicle, and turn the ignition key to the ON position.
2. Press and release the valet/programming/override switch 3 times.
3. The dash LED will flash one time, and the sounding device will beep onetime, indication the system is ready to accept programming for transmitter 1.
4. Press and hold the Arm Icon button until the sounding device emits a long beep, indicating the signal has been stored into memory.
5. If you have additional transmitters (up to 4) that need to be programmed, repeat step 4 for each transmitter.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below