Tuesday, August 28, 2018

Code Alarm CA145 Remote Programming Instructions

This Code Alarm CA145 system uses replacement remote: ELVNTRCA, CA5BLCTXELVATDB PROTX6PROTX5

Remember: This system can only program 4 remotes.If you attempt to program another remote, the system will start to delete saved remotes from it's memory in chronological order.

Do these steps to program the remote:

1. Turn the ignition switch ON.
2. Press and hold the valet button.
3. In 10 seconds the system will chirp or flash the parking lights three times.
4. Press the LOCK button of each remotes you're programming and system will respond with chirping once for each accepted remote codes.
5. Turn the ignition switch OFF once you're done. And the system will also turn programming mode off automatically after 15 seconds of inactivity.

Remember: This system has 1 button programming which programs all channels of the system.



1) Enter the vehicle, and turn the ignition switch to the On position.
2) Press and release the programming button switch 3 times.
3) Press and hold the LOCK button of the transmitter you wish to program.
4)the lights will flash 1 time, indicating that the system accepting the programming of channel#1 which is look.

"Repeat step 3 for each transmitter you wish to program"

5) Press and release the valet push button switch 1 time to advance to channel 2.
6) Press and hold the UNLOCK button of the transmitter you wish to program.
7)The lights will flash 1 time, indicating that system is accepting the programming of channel#2 which is unlock.

"Repeat step 6 for each transmitter you wish to program"

8) Press and release the valet push button switch 1 time to advance to channel 3.
9) Press and hold the TRUNK button of the transmitter you wish to program.
10) The lights will flash 1 time, indicating that the system is accepting the programming of channel#3 which is trunk.

"Repeat step 9 for each transmitter you wish to program"

11) Press and release the valet push button switch 1 time to advance to channel 4.
12) Press and hold the STAR button of the transmitter you wish to program.
13) The lights will flash 1 time, indicating that the system is accepting the programming of channel #4 which is remote start.

"Repeat step 12 for each transmitter you wish to program"

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below