Wednesday, August 29, 2018

Code Alarm CA150 Remote Programming Instructions

This Code Alarm CA150 system uses replacement remote: ELVATDB, PROTX6

1) Turn the ignition switch to the On position.
2) Press and release the valet button 3 times.
3) Press and hold LOCK button of the remote.
4) The lights will flash once.

"Re do step 3 for each additional remotes"

5) Press and release the valet button once for channel 2.
6) Press and hold the UNLOCK button on the remote
7)The lights will flash once.

"Re do step 6 for each additional remotes"

8) Press the valet button once for channel 3.
9) Press and hold the TRUNK button on the remote.
10) Then the lights will flash once.

"Do step 9 on addtional remotes"

11) Press the valet button once to advance to channel 4.
12) Press and hold the STAR button of the remote.
13) The lights will flash once.


"Go back to step 12 for programming your additional remotes"

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below