Tuesday, August 28, 2018

Code Alarm CA4050 Remote Programming Instructions

This Code Alarm CA4050 system uses replacement remote: H5OT45, CATX1B

NOTE: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order.

To program transmitters:

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp/flash the parking lights three times, release the button.
4. Press button 1 of each transmitter you wish to program. The system will respond with 1 chirp for each accepted transmitter (up to 4).
5. Turn the ignition OFF to exit programming. The system will also exit programming after 15 seconds of inactivity.

NOTE: This system has 1 button programming which programming which programs all channels of the system.


If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below