Monday, August 27, 2018

Code Alarm CA420A Remote Programming Instructions

This Code Alarm CA420A system uses replacement remote: ELVATCC, CATX420

How to program your new and existing remote:

1) Get in the vehicle, turn the key in the ignition switch to ON position.
2) Press the valet button 3 times.
3) Press and hold the button on the remote for 3 seconds, or wait until the parking lights flashes.
4) Re-do step 3 for additional remotes up to a total of 4.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below