Saturday, August 25, 2018

Code Alarm CA440TW Remote Programming Instructions

This Code Alarm CA440TW system uses replacement remote: ELVATRGA, CATX4TW

This transmitter is designed for use with your upgrade remote start system and is programmed by using the remote start's program button in combination with the transmitter button. To program this transmitter into the CA 440TW system:
1. Turn the ignition to the on position.
2. Press and release the programming button 3 times.
3. Press and hold, for 3 seconds, the button of the transmitter you wish to add until the parking light flashes, indicating the transmitter has been learned.
4. Repeat step 3 for each transmitter up to a total of 4.
5. Turn the ignition off to exit the program mode.

If you can't find your valet switch click here.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below