Wednesday, August 29, 2018

Code Alarm CA535 Remote Programming Instructions

This Code Alarm CA535 system uses replacement remote: ELVATDB, PROTX6

1) Enter the vehicle, and turn the ignition switch to the on position.
2) Press and release the programming button switch 3 times.
3) Press and hold the LOCK button of the transmitter you wish to program.
4) The lights will flash 1 time, indicating that the system accepting the programming of channel#1 which is lock.

"Repeat step 3 for each transmitter you wish to program"

5) Press and release the valet push button switch 1 time to advance to channel 2.
6) Press and hold the UNLOCK button of the transmitter you wish to program.
7) The lights will flash 1 time, indicating that system is accepting the programming of channel#2 which is unlock.

"Repeat step 6 for each transmitter you wish to program"

8) Press and release the valet push button switch 1 time to advance to channel 3.
9) Press and hold the TRUNK button of the transmitter you wish to program.
10) The lights will flash 1 time, indicating that the system is accepting the programming of channel#3 which is trunk.

"Repeat step 9 for each transmitter you wish to program"

11) Press and release the valet push button switch 1 time to advance to channel 4.
12) Press and hold the STAR button of the transmitter you wish to program.
13) The lights will flash 1 time, indicating that the system is accepting the programming of channel #4 which is remote start.

"Repeat step 12 for each transmitter you wish to program"

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below