Saturday, August 25, 2018

Code Alarm CA610 Remote Programming Instructions

This Code Alarm CA100 system uses replacement remote: ELVATCGCATX610ELVATDB, PROTX6

Usually key chain transmitters included with the system are pre-programmed, with each button pre-assigned to control a specific function of the system.

Your system can only handle up to 4 remotes. If you program another remote while system already has saved 4 of it, then the first remote you programmed will be erased from the system's memory.

Follow these steps to program your remote:

1. Turn the ignition switch to the ON position.
2. Press and release the valet button/switch 3 times.
3. The dash mounted LED will flash once, and the siren will sound once, this means your system is ready to accept programming for channel 1 which is ARM/LOCK.
4. Press and hold the LOCK button on the remote for 4 seconds and or you can just simply wait for a long chirp.
4a. Do step 4 for any addtional remotes you wish to program.
5. Press and release the valet button/switch once to channel 2 this time. The dash mounted LED will flash twice and the horn/siren will sound twice, indicating that the system is ready to accept programming for channel 2 which is DISARM/UNLOCK.
6. Press and hold the UNLOCK button on the remote for 4 seconds or wait for the long chirp.
6a. Repeat step 6 for any additional remotes you'd like to program.
7. Again, Press and release the valet button/switch once to advance to the 3rd channel. The dash mounted LED will flash 3 times and the horn/siren will sound 3 times, indicating that the system is ready to accept programming for channel 3 which is TRUNK RELEASE/REMOTE START.
8. Press and hold the TRUNK KEY/KEY BUTTON on the remote for 4 seconds or just simply wait for a long flash from the parking lights.
8a. Repeat step 8 for any additional remotes.
9. Press and release the valet button/switch once to advance to channel 4. The dash mounted LED will flash 4 times and the horn/siren will sound 4 times, indicating that the system is ready to accept programming for channel 4 which is an optional device.
10. Press and hold the OPTION button on the remote for 4 seconds or until a long flash from the parking lights.
10a. Re-do step 10 for any additional remotes.


1) Turn the ignition to On position.
2) Press the valet button 3 times.
3) Press and hold LOCK button on your remote.
4) Parking lights will flash once.

Go back to step 3 to program additional remotes.

5) Press the valet button once for channel 2.
6) Press and hold the UNLOCK button on the remote
7) Parking lights will flash once.

Go back to step 6 for each additional remotes.

8) Press the valet button once for channel 3.
9) Press and hold the TRUNK button on the remote.
10) Parking lights will flash once.

Go back to step 9 for additional remotes.

11) Press the valet button once to advance to channel 4.
12) Press and hold the STAR button on the remote.
13) Parking lights will flash once.

Go back to step 12 for additional remotes

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below