Wednesday, August 29, 2018

Code Alarm CSM4 Remote Programming Instructions

This Code Alarm CSM4 system uses replacement remote: GOH-FOUR, ELVATKC

NOTE: The system can only program to 4 remotes.

Follow steps to program your new and existing remotes:

1. Turn the ignition switch ON.
2. Press and hold the valet button.
3. In 10 seconds the system will chirp/flash the parking lights (3) times.
4. Press the LOCK button of each remotes you're programming and system will respond with chirping once for each accepted remote codes.
5. Turn the ignition switch OFF once you're done. And the system will also turn programming mode off automatically after 15 seconds of inactivity.

NOTE: This system has 1 button programming which programs all channels of the system.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below