Monday, August 27, 2018

Code Alarm Elite 4800 Remote Programming Instructions

This Code Alarm Elite 4800 system uses replacement remote: GOH-FRDPC2002, GOH-TSM-23

Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from the memory in chronological order.

To program transmitters:

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp/flash the parking lights (3) times, release the button.
4. Press Button 1 of each transmitter you wish to program. The system will respond with 1 chirp for each accepted transmitter (up to 4)
5. Turn the ignition Off to exit programming. The system will also exit the programming after 15 seconds of inactivity.

Note: This system has 1 button programming which programs all channels of the system.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below