Monday, August 27, 2018

Code Alarm SRT1600 Remote Programming Instructions

This Code Alarm SRT1600 system uses replacement remote: ELVATRFD, CATXSRT2, ELVATFF, CATXSRT1


Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is exceeded, the security system will start deleting transmitters from memory in chronological order.

To program transmitters.

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp/flash the parking lights (3) three times, release the button.
4. Press Button 1 of each transmitter you wish to program. The system will respond with 1 chirp for each accepted transmitter (up to 4).
5. Turn the ignition OFF to exit programming. The system will also exit programming after 15 second of inactivity.

Note: The system has 1 button programming which programs all channels of the system.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below