Wednesday, August 29, 2018

Code Alarm SURESTARTSE Remote Programming Instructions

This Code Alarm SURESTARTSE system uses replacement remote: GOH-FOUR, ELVATKC

Note: This mode will only retain the last 4 remote transmitter programmed. If the transmitter memory is exceed, the security system will start deleting transmitters from memory in chronological order.

To program transmitters:

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp/flash the parking lights (3) three times, release the button.
4. Press Button 1 of each transmitter you wish to program. The system will respond with 1 chirp for each accepted transmitter (up to 4).
5. Turn the ignition OFF to exit programming. The system will also exit programming after 15 seconds of inactivitiy.

NOTE: This system has 1 button programming which programs all channels of the system

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below