Friday, August 31, 2018

DEI Avital 4113 Remote Programming Instructions

This DEI Avital 4113 system uses replacement remote: 7111L,7111A, 7111R


The system comes with two remote controls that have been taught to the receiver. The receiver can store up to 4 different remote control codes in memory. Use the following learn routine to add remote controls to the system.

The Program switch, plugged into the blue part, is used for programming. There is a basic sequence of steps to remember whenever programming this unit: Key, Choose, Transmit and Release.

1. Turn the key the ignition to the ON position.

2. Choose. Within 10 seconds, press and release the Program switch the number of times corresponding to the desired channel listed next. Once you have selected the channel, press the switch once more and HOLD it. The LED will flash to confirm the selected channel. Do not release the program switch.

3. Transmit. While HOLDING the Program switch, press the key button program the remote or to reset one of the features in the remote programming grid. The horn honks to confirm that the code has been successfully programmed. it is not possible to teach a remote control to the system more than once.

4. Release. Once the code is learned, the program switch can be released.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below