Thursday, August 30, 2018

DEI Viper 300 HF Remote Programming Instructions

This DEI Viper 300 HF system uses replacement remote: EZSDEI471, 471T, 471C

System comes with one remote that is already programmed to the receiver. It can save up to 4 different remote codes in it's memory.

Do these steps to program the remote to the system or to change the button's functions.

1. Turn the key in ignition to On.

2. In 10 seconds, press the valet button the number of times corresponding to the desired channel listed below. Then you press the button one more time and HOLD it.The LED will flash to confirm. Do not release the valet button.

3. While holding the valet button, press the button on the remote that you'd like to program.

4. Once the remote is programmed, you can release the valet button.

You can program from 1 channel to another by releasing the valet switch and tapping it to advance steps and then holding it. For instance: You have programmed Channel 1 and want to program Channel 2. Release the valet switch. Press it one time and release it to advance from Channel 1 to Channel 2. Now, press and HOLD the valet switch. The LED will flash two times. As before, do not release it. If you want to program the 3rd channel after programming Channel 1, release the Program switch, press it twice and release it to advance to Channel 3. Then press it again and HOLD it. LED will flash three times to confirm it's ready to program the remote.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below