Friday, August 31, 2018

Python 880XP Remote Programming Instructions

This Python 880XP system uses replacement remote: 479V, EZSDEI472, EZSDEI478, EZSDEI478V/P/C, EZSDEI479, EZSDEI479V/P/X

Please Note: To program your remote just follow the steps below. And, in order to get your system on programming mode, you'll need Valet switch/button which usually is plugged into the BLUE port of the receiver (black small box).

1. Open driver's door.
2. Turn ignition ON using your key. (Make sure the engine did not start)
3. Within 5 seconds press the Valet button/switch the number of times corresponding to the desired channel as seen on the picture below, then press and hold it UNTIL the specific button of your remote is programmed. Your LED will flash the same number of times you pressed the valet button and you'll hear a chirp to confirm the system is in programming mode.
4. Press the button that you'd like to assign to that channel on your remote. then you'll hear another chirp to confirm that the remote has been paired.
5. Release the valet button and remove the key when you're done.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below