Audiovox AS9055T Remote Programming Instructions

This Audiovox AS9055T system uses replacement remote: ELVATCC, AVX1B4S, AVX-1B4S

ELVATCC, AVX1B4S, AVX-1B4S Remote

This remote is designed for use with your upgrade remote start unit and is programmed by using the remote start's program switch in combination with the transmitter button. Although this remote can be programmed into any of the Audiovox remote start and or alarm, alarm remote start system, it will offer limited use and should be used for the remote start upgrade only.

Follow the instructions below to program the remote:

1) Twist the key in the ignition to ON position
2) Press the valet button/switch 3 times
3) Press and hold the button of the remote for 3 seconds which you wish to add until the parking light flashes.
4) Go back to step 3 for each remote (a maximum of 4). Turn the ignition off to exit the program mode.

Please Note: Do not allow more than 15 seconds to lapse between steps or the program mode will be automatically turn off and you will need to start from the top.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.