Thursday, September 6, 2018

AutoCommand model 26036 Remote Programming Instructions

AutoCommand model 26036 system uses replacement remote: EZSDEI28171, 28161, 28171



1. Turn the ignition ON. Don't start the engine.
2. Within 5 seconds, press the switch 1 time, and then Press and hold it.
3. After 2 seconds, the LED will flash on and off one time, pause and repeat to indicate you're now in programming mode.
4. Within 15 seconds, press the * button on the transmitter to be programmed, the Horn/Siren output will pulse once to confirm programming.
5. Repeat Step 4 for each transmitter.
6. To exit programming mode: You can wait 15 seconds or turn the ignition off.The Horn/Siren output will pulse 5 times to confirm it.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below