Thursday, September 6, 2018

AutoCommand model 26727 Remote Programming Instructions

AutoCommand model 26727 system uses replacement remote: EZSDEI28171, 28161, 28171

PROGRAMMING INSTRUCTION FOR THE REMOTE:

1. Turn the key in the ignition to ON position.
2. Within 5 seconds, press and release the Momentary switch ONE time, and then Press and hold it.
3. In 2 seconds, the LED will flash on and off twice.
4. Within 15 seconds, press the * button from the remote, then the Horn/Siren will pulse which means the remote has been programmed.
5. Go back to Step 4 to add another remote.
6. Wait 15 seconds or turn the ignition off to exit transmitter programming mode. The Horn/Siren output will pulse 5 times to confirm it.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below