Tuesday, September 4, 2018

Automate 6402A Remote Programming Instructions

This Automate 6402A system uses replacement remote: 471A, EZSDEI471A

NOTE: Refer to the owner's wallet card to figure out which system (ignition or start) was installed in the car.

Ignition kill system learn procedure.

1. Key. Turn the key to the ignition position. if the power is present, then the ignition kill system is not armed. If no power is present proceed to step 3.
2. Key Off. Turn key off and wait for 40 seconds. Turn the key to the ignition position again. Power should be present.
3. Cycle. Turn the key OFF and then cyclce the key from off to ignition position 3-times within 5 seconds and then hold in the ignition position on the 4th turn.
4. Learn. Press "AUTOMATE" button found on the remote and within 5 seconds (the ignition has power). Re do this step if you're adding another remote. You can only program 4 remote in the system.
5. Test. Turn the key OFF and wait for 40 seconds.Turn the key to ignition position. The ignition should not have power. Shake the transmitter to transmit disarm signal. Turn the key to start the vehicle should crank and start. If this procedure does not work, press the button labeled "Automate" and try again.

Starter kill system learn procedure.

1. Key Start. Turn the key to the start position. if the vehicle does not start then proceed to step 3. If the vehicle starts then the starter kill system is not armed. proceed to step 2.
2. Key Off. Turn key off and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Cycle. Turn the key OFF and then cyclce the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Learn. Learn. Press "AUTOMATE" button found on the remote and within 5 seconds (the starter cranks). Re do this step if you're adding another remote. You can only program 4 remote in the system.
5. Test. Turn the key OFF and wait 40 seconds. Turn the key to start, the vehicle should not start. Shake the transmitter to transmit disarm signal, turn the key to start, the vehicle should crank and start. If this procedure does not work, press the button labeled "Automate" and try again.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below