Tuesday, September 4, 2018

Automate 6403A Remote Programming Instructions

This Automate 6403A system uses replacement remote: 471A, EZSDEI471A

ATTENTION: Check the owner's wallet card to find out which system (Start or Ignition) was installed to your car.

For STARTER kill system:

1. Turn the key to the START position. If the engine did not start then proceed to step 3. If the engine starts then the starter kill system is not armed. proceed to step 2.
2. Turn key off and wait for 40 seconds. Turn the key to the START position and the engine should not start.
3. Turn the key OFF and then cyclce the key from off to START position 3-times within 5 seconds and then hold in the START position on the 4th turn.
4. Press the button labeled "Automate" on the transmitter within 5 seconds (the starter cranks). Repeat steps above to learn up to a total of 4 transmitter.
5. Turn the key OFF and wait 40 seconds. Turn the key to start, the vehicle should not start. Shake the transmitter to transmit disarm signal, turn the key to start, the vehicle should crank and start. If this procedure does not work, press the button labeled "Automate" and try again.

For IGNITION kill system:

1. Turn the key to the IGNITION position. if the power is present, then the IGNITION kill system is not armed. If no power is present proceed to step 3.
2. Turn key off and wait for 40 seconds. Turn the key to the IGNITION position again. Power should be present.
3. Turn the key OFF and then cyclce the key from off to IGNITION position 3-times within 5 seconds and then hold in the IGNITION position on the 4th turn.
4. Press the button labeled "Automate" on the transmitter within 5 seconds (the ignition has power). Repeat steps above to program up to a total of 4 remotes.
5. Turn the key OFF and wait 40 seconds.Turn the key to ignition position. The ignition should not have power. Shake the transmitter to transmit disarm signal. Turn the key to start the vehicle should crank and start. If this procedure does not work, press the button labeled "Automate" and try again.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below