Tuesday, September 4, 2018

Automate 6404A Remote Programming Instructions

This Automate 6404A system uses replacement remote: 471A, EZSDEI471A

The following steps can be used to program this replacement remote to the system. Refer to the owner's wallet card to find which system (ignition or start) was installed.

Starter kill system program instruction.

1. Turn the key to start position. If the vehicle doesn't start jump to step 3. If the vehicle starts then the starter kill system is not armed proceed to step 2.
2. Turn the key OFF and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Turn the key OFF and then cycle the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Press the button labeled "Automate" on the transmitter within 5 seconds (the starter cranks). Repeat steps above to learn up to a total of 4 transmitter.
5. Turn the key OFF and wait 40 seconds. Turn the key to start, the vehicle should not start. Shake the transmitter to transmit disarm signal, turn the key to start, the vehicle should crank and start. If this procedure does not work, press the button labeled "Automate" and try again.

Ignition kill system program instruction.

1. Turn the key to the ignition position. If the power is present, then the ignition kill system is not armed. If no power is present proceed to step 3.
2. Turn key off and wait for 40 seconds. Turn the key to the ignition position. Power should be present.
3. Turn the key OFF and then cycle the key from off to ignition position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Press the button labeled "Automate" on the transmitter within 5 seconds (the ignition has power). Repeat steps above to program up to a total of 4 remotes.
5. Turn the key OFF and wait 40 seconds.Turn the key to ignition position. The ignition should not have power. Shake the transmitter to transmit disarm signal. Turn the key to start the vehicle should crank and start. If this procedure does not work, press the button labeled "Automate" and try again.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below