Saturday, September 8, 2018

Autopage RF-105KE Remote Programming Instructions

This Autopage RF-105KE system uses replacement remote: XT-33, H50T21

This system can only program 4 remotes. The security system will start deleting remote codes from it's memory in chronological order if the memory has exceeded.

1. Twist the ignition switch OFF/ON 3 times and stay in ON position.
2. Within 15 seconds press the valet switch/button twice and hold it on your 2nd press until a long chirp is heard. You are now in the programming mode.
3. Press and hold any button on your remote until the siren chirps.
4. If you have an additional remote, just repeat step 3 for each remotes.

To exit programming mode just twist the ignition to OFF position then you'll hear 3 long chirps and 3 parking light flashes.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below