Saturday, September 8, 2018

Autopage RS-602 Remote Programming Instructions

This Autopage RS-602 system uses replacement remote: XT-20LCD, H50TR11

Please Note: If the memory exceeded, the security system will start deleting saved remotes from it's memory in chronological order. These types of systems can only save a maximum of 4 remotes in it's memory.

1. Turn the Ignition 'switch ‘OFF/ON’ 3 TIMES and stay in the ‘ON’ position. Within 15 seconds.
2. Push the Programming switch 2 times holding in on the 2nd push, until a long chirp from the horn (optional) and the LED starts to flash then release the valet switch. You are now in the Transmitter programming mode.
3. Press the ‘Lock’ button on the transmitter until a chirp from the horn / a flash from the parking light / the LED turns on for 2 seconds to confirming the first transmitter is now programmed.
4. Apply the same procedure (step 3) to program 2nd, 3rd and 4th.

Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below