Monday, September 17, 2018

Carbine model PLUS-6900 Remote Programming Instructions

This Carbine model PLUS-6900 system uses replacement remote: ELVNTRFA, CA-RFLCD2

Attention: Your system will delete saved remotes from it's memory in chronological order once you forced it to program another remote while it's memory is full (systemcan only keep maximum of 4 remotes).

1. Turn the ignition ON.

2. Press the valet switch/button 3 times. Make sure you hear a chirp/beep.

3. Press the LOCK button on the remote until you hear a chirp/beep.

4. Go back to step 3 program additional remotes (maximum of 4).

5. Turn the ignition off or wait for 15 seconds for the system to turn programming mode OFF by itself. You should hear one short and one long chirps/beeps.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below