Thursday, September 20, 2018

Crimestopper CS-830RKE Remote Programming Instructions

This Crimestopper CS-830RKE  system uses replacement remote: CS-355TX, J5523518T1CS-361TX, J5523518T1, M65NVTX464

NOTE: This system will learn a total of 4 remotes max and this instruction applies to: 335, 336, 355, 361, 340, 341, 342, 360, 365, 366

1. Turn the ignition ON and OFF 3 times quickly, leaving it ON the 3rd time.
2. Press the Program/Override button 5 times and you should hear 5 light flashes and 6 siren chirps.
3. Press #1 (lock) button on the remote 2 times for the 360-336-365-366tx's and 1 time for the regular TX.
4. Repeat the stpes above for the second and 3rd Remote.
5. Turn off Ignition. Siren will chirp 3 times and lights will flash 3 times for exit confirmation.

NOTE: The System can only program a maximum of 3 and to program the remote

1. Turn the ignition ON and OFF 3 times quickly, leaving it ON the 3rd time. (ON/OFF, ON/OFF, ON) You should hear (1) short chirp.
2. Press the button for 5 seconds until the siren chirps (3) times. Release the button.
3. Press Button #1 on the remote then you'll hear a chirp. Go back to Step 3 within 5 sec. to program another remote.
4. Turn the ignition OFF.

Note 1: If only one transmitter is being programmed, continue pressing button #1 until dash LED flashes goes out and The system chirps to exit programming mode to prevent unauthorized codes and noise from entering the system. Programming mode is exited automatically after 5 seconds of last code transmission or once 3 new codes.

PROGRAMMING INSTRUCTIONS FOR 335, 336, 355, 361, 340, 341, 342, 360, 365, 366

1. Turn Ignition ON and OFF3 times quickly, leaving it ON the 3rd time. (ON/OFF,ON/OFF,ON) you should heard 3 chirps.
2. Press the Program/Override button 5 times and you should hear 5 light flashes and 5 siren chirps.
3 Press #1 (lock) button on the remote 2 times for the 360-336-365-366tx's and 1 time for the regular TX.
4 Repeat the steps above for the second and 3rd Remote.
5. Turn off Ignition. Siren will chirp 3 times and lights will flash 3 times for exit confirmation.

NOTE: This system will learn a total of 4 remotes max.

METHOD-2

TRANSMITTER PROGRAMMING Note:
SYSTEM can learn up to 3 different codes max.

1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3rd time. (ON/OFF,ON/OFF,ON) You should hear (1) Short chirp.
2. Push the Program/Override Button for 5 seconds until the siren chirps (3) times. Release the button. The system is now in programming mode.
3. Press Button #1 on new transmitter-siren will chirp to confirm programming. Repeat step 3 within 5 sec. for up to 2 additional transmitters.
4. Turn off Ignition.

Note 2: If only one transmitter is being programmed, continue pressing button #1 until dash LED flashes goes out and The system chirps to exit programming mode to prevent unauthorized codes and noise from entering the system.

Note 2: Programming mode is exited automatically after 5 seconds of last code transmission or once 3 new codes.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below