Sunday, September 23, 2018

Crimestopper EZ-55DP Remote Programming Instructions

This Crimestopper EZ-55DP system uses replacement remote: CS-55TX, CHX433TX

Please Note: The system can program a maximum of 4 remotes in it's memory. After programing your new remote you will need to reprogram the existing ones. The "Sidekick" transmitters for the TW1/TW2 and FM systems are a special model that is not compatible with each other.

1. Open the hood (ground the blue pin wire if there's no hood pin installed.)
2. Twist the key in the ignition to ON position. (Do not start the engine) Pink wire must be connected!
3. Press the valet button 4 times. Wait for the system to flash the parking lights and/or honk horn exactly 4 times.
4. For 1-Way system: Press the LOCK button on the remote. 2-Way systems: Press LOCK and UNLOCK button at the same time. You should get 2 light flashes and 2 horn honks which mean remote have been programmed. Now the system is waiting for a 2nd code, so repeat this step as needed with up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (3 flashes for the 2nd code, 5 flashes for the 3rd code and 0 for 4th code.) If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key OFF and close the hood.
If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below