Monday, September 24, 2018

Crimestopper FS-50 Remote Programming Instructions

This Crimestopper FS-50 system uses replacement remote: FSSK-50, Q6WBT0002

NOTE: All transmitter codes must be learned at time of programming!! These systems allow storage of up to 4 different remote codes in memory.

1. Turn key to the ON position. (Do not start the engine). Pink wire must be connected!
2. Press Program/Valet button 4 times, then a few seconds the unit flashes the parking lights 4 times.
3. Press button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting for a 2nd code, then press button #1 of a second transmitter, the unit will flash 3 times indicating it's waiting for the 3rd code and so on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key off. See diagram below.
If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below