Monday, September 24, 2018

Crimestopper FS-51 Remote Programming Instructions

This Crimestopper FS-51 system uses replacement remote: FSSK-50, Q6WBT0002

Please Read: The system can program a maximum of 4 remotes in it's memory. After programming your new remote you will need to reprogram the existing ones.

1. Twist the key in the ignition to ON position. (Don't start the engine and the pink wire must connected).
2. Press valet button 4 times, then the system will flash the parking lights 4 times.
3. Press the LOCK button then you should get 2 light flashes which means the remote has been programmed and waiting for a 2nd code.
4. If you have another remote, press the LOCK button on that remote, then the system will flash the lights 3 times indicating it's waiting for the 3rd code and so on. If all 4 remotes are programmed, the system will automatically turn the programming mode OFF, otherwise turn the ignition OFF to do it manually.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below