Monday, September 24, 2018

Crimestopper FS-60 Remote Programming Instructions

This Crimestopper FS-60 system uses replacement remote: FSSK-60, CHX433TX

Note: All transmitter codes must be learned at time of programming!! The system learns up to 4 different transmitter codes.

1. Turn Ignition Key to the ON position. (Pink wire must be connected.)
2. Press Programming button 4 times. then after a few seconds the unit Chirps, Siren, Horn and Flashes the parking lights 4 times.
3. Press button #1 of the transmitter to be coded. You should get 1 Chirp/Honk indicating the first remote is coded, and then press
button #1 of a second transmitter, the unit will Chirp/Honk twice indicating the second remote is coded and so on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise tum key off.
4. The system will Chirp/Honk 4 times when exiting learning mode.
If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below