Sunday, September 23, 2018

Crimestopper RS-830 Remote Programming Instructions

This Crimestopper RS-830 system uses replacement remote: CS-330TX, J5523518T1RSTX-3, VVJ-T612S434
and

INSTRUCTION: The system can program a maximum of 4 remotes in it's memory. After programming your new remote you will need to reprogram the existing ones.

1. Turn key to the ON position. (Do not start the engine). Pink wire must be connected!
2. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times.
3. RS-3, RS- 4: Press button#1 (Lock) of the transmitter to be learned. 2-Way systems: Both the Lock & Unlock buttons must be pressed. You should get 2 light flashes and 2 horn honks indicating the code-learn. Now the unit is waiting for a 2nd code, so repeat this step as needed with up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (3 flashes for the 2nd code, 4 flashes after the 3rd code and 0 for 4th code.) If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below