Saturday, September 8, 2018

DEI 4105V Remote Programming Instructions

This DEI 4105V system uses replacement remote: 7145V, EZSDEI7141, 3105V, 4105V, 3305V

Please Note: Your red LED must be off and make sure to turn your Alarm off as well since the Valet button/and switch won't work while leaving the alarm turned on. If there is no working remote and the alarm sounds when you open the door or start the vehicle then do the following: Press valet switch for one second and release with the ignition ON. If that doesn’t work then do it with ignition OFF.

Adding a new remote for DEI system 4105V:

1. Open driver door until the remote is programmed.
2. Turn the ignition to ON.
3. Within 5 seconds of step 2 press the valet/program switch 1 time, release it, press it again and hold it. You may hear a chirp, beep, or honk and the LED light on dash will flash once. Do not release button.
4. Within 5 seconds press the arm button on the remote transmitter. You may hear chirp, beep, or honk.
5. Release the valet/programming switch.
6. Turn ignition to OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below