Monday, September 3, 2018

DEI Automate 2, 5+ Remote Programming Instructions

This Automate 2, 5+ system uses replacement remote: 493C , EZSDEI467
493C EZSDEI467 Remote

Please Note: Alarm must be disarmed. Valet mode won’t work. The red LED must be off. If there is no working remote and the alarm sounds when you open the door or start the vehicle then do the following: Press valet switch for one second and release with the ignition ON. If that did not work then do it with ignition OFF.

Follow the steps to program your remote:

1. Open the driver's door.
2. Press the valet switch/button located under dash on driver’s side.
3. Turn the key in the ignition to ON position.
4. Within 5 seconds, press the valet switch/button once, then press and hold it. You may hear a chirp, beep or honk.
5. Within 5 seconds press the left button on the remote for 2 seconds and you may hear chirp, beep, or honk.
6. Release the valet switch/button, press again and release it, then press and hold it. Press the right button on the remote and release the valet switch/button, press again, release it, then press and hold it. Press both buttons on the remote and get a chirp, beep, or honk.
7. Release the valet switch button and turn the key in the ignition to OFF.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below