Tuesday, September 4, 2018

DEI Automate 5+ Remote Programming Instructions

This DEI Automate 5+ system uses replacement remote: 492T, EZSDEI467, EZSDEI492, EZSDEI493, EZSDEI493C

NOTE: Valet switch/button is plugged in to the blue port of your receiver before you proceed programming the remote:

1. Leave the driver's door open.
2. Turn the key in the ignition to ON position.
3. Within 15 seconds, press the Valet switch/button the number of times corresponding to the channel you wish to program. Once you have selected the channel, press the button once more and HOLD it. The unit will chirp one, two or three times depending on the channel selected. Do NOT release the Valet/Program button.

4. While holding the Valet switch/button, press the button on the remote that you would like to control. One chirp will confirm that code has been saved.
5. Release the valet switch/button.

You can advance from one channel to another by releasing the Valet/Program button and tapping it to advance channels and then holding it. For instance:You have programmed channel two. Release the Valet/Program button. Press it one time and release to advance from channel one to channel two. Press and hold the button down and the unit will chirp twice. As before, do not release. Then if you want to program channel three after programming channel two, release the Valet/Program button, press the button again and release it to advance to channel three. Then press it once more to hold it. The siren will chirp three times to confirm that it is ready to receive the code from the transmitter.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below