Saturday, September 1, 2018

DEI Automate AM6 Remote Programming Instructions

This DEI Automate AM6 system uses replacement remote: 473A, EZSDEI474V

Refer to the owner's wallet card to find which system (ignition or start) was installed.

Ignition kill system learn procedure.

1. Key. Turn the key to the ignition position. if the power is present, then the ignition kill system is not armed. If no power is present proceed to step 3.
2. Key Off. Turn key off and wait for 40 seconds. Turn the key to the ignition position again. Power should be present.
3. Cycle. Turn the key OFF and then cyclce the key from off to ignition position 3-times within 5 seconds and then hold in the ignition position on the 4th turn.
4. Learn. Press button 1 on the transmitter within 5 seconds (ignition has power). Repeat steps above to learn up to a total of 4 transmitter.
5. Test. Turn the key OFF and wait 30 seconds. Press transmitter button 1, turn the key to ignition position. The ignition should not have power. Test transmitter button 2. Turn the key to ignition and press transmitter button 2. Turn the key to start. the vehicle should crank and start.

Starter kill system learn procedure.

1. Key Start. Turn the key to the start position. if the vehicle does not start then proceed to step 3. If the vehicle starts then the starter kill system is not armed. proceed to step 2.
2. Key Off. Turn key off and wait for 40 seconds. Turn the key to the start position and the vehicle should not start.
3. Cycle. Turn the key OFF and then cyclce the key from off to start position 3-times within 5 seconds and then hold in the start position on the 4th turn.
4. Learn. Press button 1 on the transmitter within 5 seconds (the starter cranks). Repeat steps above to learn up to a total of 4 transmitter.
5. Test. Turn the key OFF and wait 30 seconds. Press transmitter button 1, turn the key to start, the vehicle should not start. Test transmitter button 2. Turn the key to ignition and press transmitter button 2. Turn the key to start. the vehicle should crank and start.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below