Monday, September 3, 2018

DEI Equalizer 1 Remote Programming Instructions

This Equalizer 1 system uses replacement remote: 491T, EZSDEI490, EZSDEI491, EZSDEI471

Disarm the Alarm and the red LED must be off before programming. If the alarm sounds when you open the door or start the car without using a working remote, then press the valet switch/button while the ignition is ON. If it did not work try doing it again while the ignition is OFF.

Perform these steps to program your new remote:

1. The driver's door must be left open until the remote is programmed.
2. Press the valet button.
3. Turn the ignition to ON.
4. Within 5 seconds of step 3 press the valet button once, release it, press it again and hold it. You may hear a chirp, beep, or honk.
5. Within 5 seconds press left button on remote for 2 seconds. You may hear chirp, beep, or honk.
6. Release the valet switch/button, press again, and release it, press again, hold it. Press the right button on the remote (get chirp, beep, or honk) and release the valet switch/button, press again, release it, press again and hold it. Press both buttons on the remote and get a chirp, beep, or honk. Then release the valet switch/button.
7. Turn the ignition OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below