Monday, September 3, 2018

DEI Sidewinder 3500 Remote Programming Instructions

This Sidewinder 3500 system uses replacement remote: EZSDEI490, EZSDEI491, EZSDEI471, 491T

Alarm must be disarmed. Valet mode won’t work. The red LED must be off. If there is no working remote and the alarm sounds when you open the door or start the vehicle then do the following: Press valet switch for one second and release with the ignition ON. If that doesn’t work
then do it with ignition OFF.

To program the remote:

1. Open driver door until the remote is programmed.
2. Press the valet/program button located under dash on driver’s side.
3. Turn the ignition to ON.
4. Within 5 seconds of step 3 press the valet/program switch 1 time, release it, press it again and hold it. You may hear a chirp, beep, or honk.
5. Within 5 seconds press left button on remote for 2 seconds. You may hear chirp, beep, or honk.
6. Release the valet/program switch, press again, and release it, press again, hold it.
Press the right button on the remote (get chirp, beep, or honk) and release the
valet/program switch, press again, release it, press again and hold it. Press both
buttons on the remote and get a chirp, beep, or honk.
7. Release the valet/programming switch.
8. Turn ignition to OFF.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below