Monday, September 3, 2018

DEI Viper 600HF Remote Programming Instructions

This Viper 600HF system uses replacement remote: EZSDEI490, EZSDEI491, EZSDEI471, 491T

Note if the alarm sounds when you open the door or start the car it means it's currently on/armed so we would need to deactivate it by pressing the valet switch with the ignition ON. If it did not work, press the switch while the ignition is OFF. Also red LED must be turned off.

Here are the steps to program the remote:

1. Open the driver door until the remote is programmed.
2. Press the valet/program button.
3. Turn the key the ignition to ON position.
4. Within 5 seconds of step 3 press the valet/program switch once, release it, press it again and hold it this time. You may hear a chirp, beep, or honk.
5. Within 5 seconds press left button on remote for 2 seconds. You may hear chirp, beep, or honk.
6. Release the valet/program switch, press again, and release it, press again, hold it.
Press the right button on the remote (get chirp, beep, or honk) and release the
valet/program switch, press again, release it, press again and hold it. Press both
buttons on the remote and get a chirp, beep, or honk. Release the valet/programming switch. Turn ignition to OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below