Monday, September 3, 2018

DEI Viper C 50 Remote Programming Instructions

This DEI Viper C 50 system uses replacement remote: 493C, EZSDEI467

Check if your alarm sounds when you open the door or start the car. And if it did, press valet switch for one second and release with the ignition ON. If that did not work, press the switch while the ignition is OFF.

Here are the steps to program the remote:

1. Open the driver door until the remote is programmed.
2. Press the valet/program button located under dash on driver’s side.
3. Turn the ignition to ON.
4. Within 5 seconds of step 3 press the valet/program switch once, release it, press it again and hold it this time. You may hear a chirp, beep, or honk.
5. Within 5 seconds press left button on remote for 2 seconds. You may hear chirp, beep, or honk.
6. Release the valet/program switch, press again, and release it, press again, hold it. Press the right button on the remote (get chirp, beep, or honk) and release the valet/program switch, press again, release it, press again and hold it. Press both buttons on the remote and get a chirp, beep, or honk.
7. Release the valet/programming switch.
8. Turn ignition to OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below