Tuesday, September 4, 2018

DEI Wasp 718W Remote Programming Instructions

This Wasp 718W system uses replacement remote: 492T, EZSDEI467, EZSDEI492, EZSDEI493, EZSDEI493C

Please note: The following instruction can be used to program the replacement transmitter to the system. in order to enter the instruction, the system's Valet/Program button must be plugged into the blue port.

To enter the transmitter/receiver instruction:

1. Door. Open a Door.
2. Key. Turn the ignition on to the position.
3. Choose. Within 15 seconds. press and release the Valet/Program button the number of times corresponding to the channel you wish to program. Once you have selected the channel, press the button once more and HOLD it. The unit will chirp one, two or three times depending on the channel selected. Do NOT release the Valet/Program button.

4. Transmit. While holding the Valet/Program button, press the button on the transmitter that you would like to control the selected receiver channel. One chirp will confirm that code has been learned.
5. Release. Once the code is learned, the button can be released. You can advance from one channel to another by releasing the Valet/Program button and tapping it to advance channels and then holding it.

For instance: You have programmed channel two. Release the Valet/Program button. Press it one time and release to advance from channel one to channel two. Press and hold the button down and the unit will chirp twice. As before, do not release. Then if you want to program channel three after programming channel two, release the Valet/Program button, press the button again and release it to advance to channel three. Then press it once more to hold it. The siren will chirp three times to confirm that it is ready to receive the code from the transmitter.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below