Saturday, September 15, 2018

Karr 2020 Remote Programming Instructions

This Karr 2020 system uses replacement remote: ELVAT5H

If you are programming an original remote (Z5000A or Z5000B:)

1. Enter the vehicle and turn the ignition to ON.
2. Move the valet/ bypass switch ON – OFF 3 times. The LED will flash once, and the siren or horn will chirp once.
3. Hold down the center transmitter button for three seconds. This will program button one.
4. If you need to program a second channel then flip the valet / bypass switch ON- OFF. The LED will flash twice and the siren or horn will chirp twice.
5. Hold down button #2 for three seconds.
6. Turn vehicle OFF.

If you are programming a clone remote (Z5000E:)

1. Enter the vehicle and turn the ignition to ON.
2. Move the valet/ bypass switch ON – OFF 3 times. The LED will flash once, and the siren or horn will chirp once.
3. Hold down the LOCK transmitter button for three seconds. This will program button one and two.
4. If you need to program a second channel then flip the valet / bypass switch ON- OFF. The LED will flash twice and the siren or horn will chirp twice.
5. Hold down the TRUNK button for three seconds.
6. Turn vehicle OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below