Sunday, September 16, 2018

Karr 2040a Remote Programming Instructions

This Karr 2040a system uses replacement remote: ELVAT5H

These steps only works on the original remotes with the FCC ID: Z5000A or Z5000B.

1. Turn the ignition ON. (Make sure engine did not start).
2. Press the valet switch/button (ON and OFF) 3 times. Your LED will flash and siren chirps once.
3. Press and hold the button in the middle of your remote for 3 seconds. This will program button one of your remote.
4. To program a second channel, turn the valet switch/button ON and OFF. LED will flash and siren chirps twice.
5. Press and hold the 2nd button for three seconds and turn ignition OFF.

These steps only works on the generic replacement remote with the FCC ID: Z5000E.

1. Turn the ignition ON. (Make sure engine did not start).
2. Press the valet switch/button (ON and OFF) 3 times. Your LED will flash and siren chirps once.
3. Press and hold the LOCK button on the remote for 3 seconds. This action will program 1st and 2nd button of the remote.
4. To program a second channel just turn the valet button/switch ON and OFF. LED will flash and siren chirps twice.
5. Press and hold the TRUNK button for three seconds.
6. Turn the ignition OFF.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below