Thursday, September 13, 2018

Omega C-2+P Remote Programming Instructions

This Omega C-2+P system uses replacement remote: L2MAL41T, 110, 210

Please Note: Your alarm must be off and valet switch is accessible so you can program the remote to the system.

1) Twist the key in the ignition to ON position.
2) Within 7 seconds press the valet switch/button 5 times. You'll hear a chirp as a confirmation from putting the system to programming mode.
3) Press the LOCK button on the remote (for Freedom 500, C-5, and K9 Mundial2, press 2nd or 3rd channel. For MARS-22, press Lock & Unlock at the same time). And you'll hear short siren chirp.
4) Follow step 3 for adding another remote to the system (up to 4 remotes).

Attention: Your system will exit the programming mode after 15 seconds of being idle.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below