Thursday, September 13, 2018

Omega FBI 517 Remote Programming Instructions

This Omega FBI 517 system uses replacement remote: L2MAL41T, 128-09

Please Note: This alarm automatically turns programming mode once powered up. Make sure that all points of entry (doors, trunk, hood) are closed before your start. If there is a hood pin switch, have someone hold it down or temporarily disconnect it. The system will not enter programming mode if it detects an open point of entry. The system will automatically turn programming mode OFF if it detects a 15 second period of no activity.

Follow all steps below to program the remote:
If the system has been without power for more than 24 hours:
1) Apply power to the system.
2) Press the large/ lock button (Press small center button for Freedom 400) on your remote. The system should respond with a short siren chirp.
3) Repeat step 2 for each additional remote that is to operate the system.

If your system had power within the last 24 hours:
1) Disconnect and re-apply power.
2) Press the large button (Press small center button for Freedom 400) on any remote that does not already operate the system (this is how the system determines that you want to program transmitters). The system should respond with a short siren chirp.
3) Repeat step 2 for each additional remote that is to operate the system.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below