Thursday, September 13, 2018

Omega K9-TWO-C Remote Programming Instructions

This Omega K9-TWO-C system uses replacement remote: ELV147, 149-07

Attention: Before you start, your system must be in a disarmed state and you must know where your valet switch is located. Perform the following steps:

1) Turn the vehicle's ignition to the "on" position
2) Within 7 seconds of step 1, press the valet switch 5 times. The alarm should respond with a long siren chirp.

One Button Remote:
3) Press the button on your remote. The alarm should respond with a short siren chirp.
4) Press the valet switch one time.
5) Proceed to step 6.

Two button remote:
3) Press the large button on our remote. The alarm should respond with a short siren chirp.
4) Press both buttons at the same time. The alarm should respond with 2 short siren chirps
5) Press the small button on your remote. The alarm should respond with 3 short siren chirps.

Three button remote:
3) Press the large button on your remote. The alarm should respond with a short siren chirp.
4) Press the small right button on your remote. The alarm should respond with 2 short siren chirps.
5) Press the small left button on your remote. The alarm should respond with 3 short siren chirps.
6) Repeat steps 3-5 for each additional remote that you wish to operate your system (up to 4
remotes).

Note: the system will automatically exit programming mode if it detects a 15 second period of no activity.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below