Thursday, September 13, 2018

Omega M.A.T.-10ATV Remote Programming Instructions

This Omega M.A.T.-10ATV system uses replacement remote: L2MET5A, L2MET7A, 103-01, 103-02, 103-03, 103-05, 103-08

Please Note: Your alarm must be off and valet switch is accessible so you can program the remote to the system.

1) Twist the key in the ignition to ON position.
2) Within 7 seconds press the valet switch/button 5 times. You'll hear a chirp as a confirmation from putting the system to programming mode.
3) Press the LOCK button on the remote (for Freedom 500, C-5, and K9 Mundial2, press 2nd or 3rd channel. For MARS-22, press Lock & Unlock at the same time). And you'll hear short siren chirp.
4) Follow step 3 for adding another remote to the system (up to 4 remotes).

Attention: Your system will exit the programming mode after 15 seconds of being idle.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below