Thursday, September 13, 2018

Omega M.A.T. 5C Remote Programming Instructions

This Omega M.A.T. 5C system uses replacement remote: ELV147, 149-07

Please Note: This system can save up to 4 remotes in it's memory and will automatically exit programming mode if it detects a 15 second period of no activity. In programming the system it's alarm must be turned off first and make sure you have an access to the valet button/switch.

1) Turn the ignition to ON suing your key.
2) Within 7 seconds press the valet button/switch 5 times. The siren should make a long chirp.

Remote with one button only:
3) Press the button on your remote. The siren should make a long chirp.
4) Press the valet switch once.
5) Proceed to step 6.

Remote with two buttons:
3) Press the large button on our remote. The siren should make a long chirp.
4) Press both buttons at the same time. The siren should make 2 long chirps.
5) Press the small button on your remote. The siren should make 3 long chirps.

Remote with three buttons:
3) Press the large button on your remote. The alarm should respond with a short siren chirp.
4) Press the small right button on your remote. The alarm should respond with 2 short siren chirps.
5) Press the small left button on your remote. The alarm should respond with 3 short siren chirps.
6) Perform steps 3-5 to program another remote.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below