Saturday, September 8, 2018

Prestige APS155 Remote Programming Instructions

This Prestige APS155 system uses replacement remote: APS99BT3BCF31, APS99BT330, ELVATOA 

1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Move the valet/bypass switch on - off - on - off- on then off.
3. The dash L.E.D. will flash one time, and the siren will "chirp" one time, indicating the system is
ready to accept programming for channel 1, or the arm/disarm and panic functions.
4. You can assign any of the three transmitter button functions listed below to channel 1:
a) Pressing button #1 on the keychain transmitter.
b) Pressing button #2 on the keychain transmitter.
c) Pressing both buttons simultaneously on the keychain transmitter.
5 Press and hold the selected choice a, b, or c above, until the siren emits a long "chirp" to confirm
that programming of channel I was successful.
6. Move the valet/bypass switch on, and then off again.
7. The dash mounted L. E. D. will flash 2 times and the siren will "chirp" one time, indicating that
the system is ready to accept programming for channel 2, or the pulsed ground output for remote
trunk release, remote car starter, etc.
8. You can assign anyone of the two remaining button functions listed in 4a, 4b, or 4c above to
operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to operate channel 2.
9. Press and hold the selected choice. The siren will emit a long "chirp" to confirm that programming of channel 2 was successful.
10. Move the valet/bypass switch on, and then off again.
11. The dash mounted L.E.D. will flash 3 times and the siren will "chirp" one time, indicating that
the system is ready to accept programming for channel 3.
12. Press and hold the remaining transmitter button function. The siren will emit a long "chirp" to
confirm that programming of channel 3 was successful.
13. To exit program mode, either turn the ignition key to the off position, or move the valet switch
on then off one additional time. This is indicated by a long "chirp" from the siren.

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below