Thursday, September 6, 2018

Ready Start model 24739T Remote Programming Instructions

Ready Start model 24739T system uses replacement remote: EZSDEI28171, 28161, 28171


INSTRUCTION:

1. Turn the ignition to the ON position.
2. Within 5 seconds, press and release the Momentary switch ONE time, and then Press and hold it.
3. After 2 seconds, the LED will flash on/off one time, pause and repeat to indicate Auto-programming is ready.
4. Within 15 seconds, press the * buton on the transmitter to be programmed, the Horn/Siren output will pulse once to confirm programming.
5. Repeat Step 4 for each transmitter.
6. Exit programming: Wait 15 seconds or turn the ignition off to exit transmitter programming. The Horn/Siren output will pulse 5 times to confirm exit.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below