Tuesday, January 29, 2019

Automate 410A Remote Programming Instructions

This Automate 410A system uses replacement remote: EZSDEI474V

Replacement Remote EZSDEI474V, 5500 XS

Model 474V, 4 Button HF, Stealth Code Remote

The following Learn Routine can be used to program this replacement transmitter to the system. In order to enter the Learn Routine, the system's Valet/Program switch must be plugged into the BLUE port.

1. Door. Open a door.
2. Key. Turn the key to the ON position.
3. Choose. Within 5 seconds press and release the Valet/Program button the number of times corresponding to the desired channel listed below.Once you have selected the channel, press the Valet/Program button once more and hold it. The LED will flash the same number of times as the channel selected and the siren(if connected) will chirp to confirm the selected channel. Do Not release the button.
4. Transmit. While holding the Valet/Program button, press the button from the transmitter you wish to assign to that channel. The unit will chirp (if horn or siren connected) to confirm that the transmitter has been taught to the receiver.
5. Release. Once the code is learned you can release the Valet/Program button and remove the key.


If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below